&引用；systemctl:未找到命令"；在fresh CentOS 6.5上安装vagrant

我正在使用我安装的CentOS 6.5的virtualbox映像创建一个新的vagrant box。内部看起来一切正常，但从外部看，我无法访问80端口

当我编辑我的文件并添加固定IP时： config.vm.network“专用_网络”，ip:“10.10.10.10” 我跑向流浪者，我得到了“未找到systemctl命令”

我认为它试图设置网络接口，但失败了，因为它使用了systemctl，我想这在这个版本或发行版中是不可用的。 有没有办法添加它，或者手动配置IP/网络接口？让vagrant连接到它

==> default: Attempting graceful shutdown of VM...
==> default: Clearing any previously set forwarded ports...
==> default: Clearing any previously set network interfaces...
==> default: Preparing network interfaces based on configuration...
    default: Adapter 1: nat
    default: Adapter 2: hostonly
==> default: Forwarding ports...
    default: 22 (guest) => 2222 (host) (adapter 1)
==> default: Running 'pre-boot' VM customizations...
==> default: Booting VM...
==> default: Waiting for machine to boot. This may take a few minutes...
    default: SSH address: 127.0.0.1:2222
    default: SSH username: vagrant
    default: SSH auth method: private key
==> default: Machine booted and ready!
==> default: Checking for guest additions in VM...
==> default: Configuring and enabling network interfaces...
The following SSH command responded with a non-zero exit status.
Vagrant assumes that this means the command failed!

systemctl stop etcd
ifconfig 10.10.10.10 netmask 255.255.255.0
mv /tmp/etcd-cluster.service /media/state/units/
systemctl restart local-enable.service

# Restart default etcd
systemctl start etcd


Stdout from the command:



Stderr from the command:

bash: line 3: systemctl: command not found
SIOCSIFNETMASK: No such device
SIOCGIFADDR: No such device
SIOCSIFBROADCAST: No such device
mv: cannot move `/tmp/etcd-cluster.service' to `/media/state/units/': No such file or directory
bash: line 6: systemctl: command not found
bash: line 9: systemctl: command not found

---

不确定这是否是原因，但罪魁祸首可能是SELinux。可能它阻止了连接或权限。让它稍后工作：

setenforce Permissive
nano /etc/sysconfig/selinux
#setting SELINUX=disabled

---

不确定这是否是原因，但罪魁祸首可能是SELinux。可能它阻止了连接或权限。让它稍后工作：

setenforce Permissive
nano /etc/sysconfig/selinux
#setting SELINUX=disabled

---

systemctl

是新centos7的一部分，它在centos65上不可用-您是从提供脚本运行此命令还是如何运行此命令？否，这是由vagrant在我更改vagrant文件并添加固定IP:config.vm.network“private_network”时生成的，IP:“10.10.10”sytemd不是Centos6的初始系统，因此无法提供

systemctl

。

systemctl

是新centos7的一部分，但在centos65上不可用-您是从供应脚本运行此命令还是如何运行此命令？不，这是由vagrant在我更改vagrant文件并添加固定IP:config.vm.network“private_network”时生成的，IP:“10.10.10.10”系统不是Centos6的初始系统，因此无法提供

systemctl

。