Docker 当HyperV打开时,Vagrant在SSH连接上冻结
这是我的配置:Docker 当HyperV打开时,Vagrant在SSH连接上冻结,docker,vagrant,virtualbox,hyper-v,Docker,Vagrant,Virtualbox,Hyper V,这是我的配置: Windows 10 PRO(打开HyperV时) 流浪汉(2.2.13) VirtualBox(6.1.16) 我读到上层配置应该在不切换“hypervisorlaunchtype”的情况下工作,但有点问题: λ vagrant up Bringing machine 'default' up with 'virtualbox' pr
- Windows 10 PRO(打开HyperV时)
- 流浪汉(2.2.13)
- VirtualBox(6.1.16)
λ vagrant up
Bringing machine 'default' up with 'virtualbox' provider...
==> default: Checking if box 'sternpunkt/jimmybox' version '3.0.2' is up to date...
==> default: Clearing any previously set forwarded ports...
==> default: Clearing any previously set network interfaces...
==> default: Preparing network interfaces based on configuration...
default: Adapter 1: nat
default: Adapter 2: hostonly
==> default: Forwarding ports...
default: 80 (guest) => 8080 (host) (adapter 1)
default: 22 (guest) => 2222 (host) (adapter 1)
==> default: Running 'pre-boot' VM customizations...
==> default: Booting VM...
==> default: Waiting for machine to boot. This may take a few minutes...
default: SSH address: 127.0.0.1:2222
default: SSH username: vagrant
default: SSH auth method: private key
Timed out while waiting for the machine to boot. This means that
Vagrant was unable to communicate with the guest machine within
the configured ("config.vm.boot_timeout" value) time period.
If you look above, you should be able to see the error(s) that
Vagrant had when attempting to connect to the machine. These errors
are usually good hints as to what may be wrong.
If you're using a custom box, make sure that networking is properly
working and you're able to connect to the machine. It is a common
problem that networking isn't setup properly in these boxes.
Verify that authentication configurations are also setup properly,
as well.
If the box appears to be booting properly, you may want to increase
the timeout ("config.vm.boot_timeout") value.
Vagrant、VB和Windows是最新版本。当hypervisorlaunchtype关闭时,Vagrant正常运行。我不得不暂时同时使用Vagrant和Docker。我找到了解决问题的方法:
v.customize ["modifyvm", :id, "--cableconnected1", "on"]
刚刚把它添加到文件中
[编辑]
有时它运行得很快,有时运行需要几分钟,但有时它不运行并返回超时警告