Ubuntu:Can';t连接到主机';使用NAT的internet连接
我在Virtualbox上安装了Lubuntu。我使用的是Windows7x64。我的虚拟机是32位版本。internet使用桥接适配器工作,但我正在尝试使用NAT,以便使用VPN。在Windows的网络和共享中心中,我看到连接“仅限于VirtualBox主机连接”,上面写着“无法访问Internet”。在属性中,选中“VirtualBox桥接网络驱动程序”。以下是ifconfig的输出:Ubuntu:Can';t连接到主机';使用NAT的internet连接,ubuntu,networking,connection,virtualbox,Ubuntu,Networking,Connection,Virtualbox,我在Virtualbox上安装了Lubuntu。我使用的是Windows7x64。我的虚拟机是32位版本。internet使用桥接适配器工作,但我正在尝试使用NAT,以便使用VPN。在Windows的网络和共享中心中,我看到连接“仅限于VirtualBox主机连接”,上面写着“无法访问Internet”。在属性中,选中“VirtualBox桥接网络驱动程序”。以下是ifconfig的输出: dev@dev-VirtualBox:~$ ifconfig eth0 Link encap:E
dev@dev-VirtualBox:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 08:00:27:f3:48:24
inet addr:10.0.2.15 Bcast:10.0.2.255 Mask:255.255.255.0
inet6 addr: fe80::a00:27ff:fef3:4824/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:379 errors:0 dropped:0 overruns:0 frame:0
TX packets:421 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:32105 (32.1 KB) TX bytes:34987 (34.9 KB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:856 errors:0 dropped:0 overruns:0 frame:0
TX packets:856 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:56432 (56.4 KB) TX bytes:56432 (56.4 KB)
路由表:
dev@dev-VirtualBox:~$ route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
default 10.0.2.2 0.0.0.0 UG 0 0 0 eth0
10.0.2.0 * 255.255.255.0 U 1 0 0 eth0
dev@dev-VirtualBox:~$
连接编辑器:
常规:当此网络不可用时自动连接到此网络,所有用户都可以连接到此网络
以太网:MTU自动
IPV4:自动(DHCP),需要IPV4寻址才能完成此连接
IPV6:忽略
dev@dev-VirtualBox:~$ cat /etc/network/interfaces
# interfaces(5) file used by ifup(8) and ifdown(8)
auto lo
iface lo inet loopback
事实证明NetworkManager并没有用名称服务器更新/etc/resolv.conf 重新启动后,在/etc/NetworkManager/NetworkManager.conf中注释掉dns=dnsmasq有效 从这里开始(第一个解决方案对我不起作用)
只需键入以下命令:
sudo dpkg-reconfigure resolvconf